Most published figures put a metal roof between roughly $4 and $16 per square foot for the roof material and installation of common steel, aluminum and corrugated systems, and well above that for copper. Where your home lands depends on the metal, the roof’s shape and pitch, and how much labor the job takes. The better question is cost per year of service: a roof that lasts several decades spreads a higher upfront price over a much longer life. At Revive Exteriors, we install metal roofing across Northern Michigan, and this guide gives you the numbers to read any quote with confidence.

Revive Exteriors
Plan Your Metal Roof With Confidence
Revive Exteriors installs metal roofing across Northern Michigan, with project management and quality craftsmanship for lasting results.

Visit

TL;DR

  • NerdWallet’s 2026 guide lists per-square-foot prices of $4–$7 for corrugated metal, $6–$16 for steel, $8–$12 for aluminum, $8–$14 for standing seam and $16–$30 for copper.
  • For a 2,000 sq ft roof, those rates translate to about $8,000 to $14,000 for corrugated and $16,000 to $28,000 for standing seam. Other sources run higher, because scope differs.
  • Labor is a large share of the bill, often 60% to two-thirds, so roof shape, pitch and complexity matter as much as the metal.
  • Quality metal roofs are generally cited at 40 to 70 years, with some systems and metals well beyond that, versus 12 to 30 for asphalt.
  • A written, line-by-line quote from a licensed local contractor is the only number that applies to your house.

Table of Contents

What a metal roof costs per square foot

Roofers price by the square foot of roof surface, and a “square” is 100 square feet. A 2,000 sq ft roof is 20 squares. Published ranges vary because some count material only and others include labor, trim and tear-off.

NerdWallet’s 2026 metal roof guide lists these per-square-foot prices by type:

Metal roof type Price per sq ft (NerdWallet) Arithmetic for a 2,000 sq ft roof
Corrugated metal $4–$7 $8,000–$14,000
Tin $3–$15 $6,000–$30,000
Metal slate $5–$12 $10,000–$24,000
Steel $6–$16 $12,000–$32,000
Zinc $6–$10 $12,000–$20,000
Aluminum $8–$12 $16,000–$24,000
Standing seam (aluminum or zinc-coated steel) $8–$14 $16,000–$28,000
Copper $16–$30 $32,000–$60,000

The right-hand column is simple multiplication of the listed range by 2,000, not a published quote. NerdWallet also reports an overall average of $5,500 to $15,500, with most projects just under $10,500, which reflects smaller roofs and simpler systems.

A higher benchmark comes from This Old House’s 2026 cost guide, which uses Homewyse data. It puts metal roofing at about $29 per square foot installed, roughly $58,000 for a 2,000 sq ft home. Its builder-grade material-only prices are $17 per square foot for zinc, $20 for steel and tin, $21 for aluminum and $35 for copper.

Why the gap? Each source defines the job differently: material grade, panel profile, whether the old roof is removed, and how much trim and flashing is included. Treat the published ranges as a map of the territory, not a quote.

What a metal roof costs per square foot

A worked example: a 2,000 sq ft roof

Say your home has a 2,000 sq ft roof, 20 squares, with a moderate pitch and a couple of valleys.

  • Corrugated or exposed-fastener steel panels: using NerdWallet’s $4–$7 corrugated range, expect something like $8,000 to $14,000 at the low end of the market.
  • Standing seam steel or aluminum: at $8–$14 per square foot, the arithmetic is $16,000 to $28,000. Standing seam uses hidden fasteners, which NerdWallet notes are typically more expensive than exposed fasteners.
  • Copper standing seam: at $16–$30, the arithmetic is $32,000 to $60,000. Copper is a premium, architectural choice, and you can see what that looks like in our copper standing seam metal roof and board and batten siding project.

Now add the items that often sit outside a per-square-foot figure: removing and disposing of the old roof, replacing damaged decking, gutters and vents. A good quote lists each one separately so you can compare like with like.

Revive Exteriors, 1650 Barlow Street, 49686 Traverse City
Revive Exteriors
Explore Your Metal Roofing Options
Visit Revive Exteriors to discuss metal roofing, energy-efficient solutions, and exterior remodeling tailored to Northern Michigan homes.
Revive Exteriors
1650 Barlow Street, 49686 Traverse City

Get directions

What moves the price up or down

Labor and roof complexity

Labor is the biggest lever. This Old House puts it at about 60% of the total for metal roof replacement, including specialized equipment and scaffolding. NerdWallet says labor can reach as much as two-thirds of the cost.

The Metal Roofing Alliance, an industry association, notes that a contractor needs the roof’s style, shape and pitch to estimate. It adds that shape and pitch influence installation cost more than the style of metal does. Staging area, material storage, hips and valleys all add time. NerdWallet also points out that steep-pitch roofs need special equipment, which raises the total.

In practice, a simple gable roof with two clean planes costs far less per square foot than a cottage with dormers, a chimney and several valleys. Two homes of identical square footage can differ by thousands.

The metal itself

Steel is the common workhorse. Aluminum is a frequent choice where corrosion is a concern. Zinc and copper sit at the premium end and are chosen for longevity and look. The profile matters as much as the metal: corrugated panels are the least expensive, standing seam costs more and looks cleaner, and metal shingles or stone-coated steel imitate traditional roof styles. Our comparison of stone-coated steel and asphalt shingles for Michigan winters walks through that option.

Fasteners, coatings and trim

Hidden-fastener systems cost more up front than exposed fasteners. Premium paint finishes, snow guards, custom flashing and ridge details also add to the line items. Ask that each be named in your quote.

Tear-off and repairs

Removing an existing roof, checking the decking and replacing rotten boards are part of a real replacement. Surprises under the old roof are the most common reason a final bill differs from the first estimate, which is why we walk the roof and inspect before quoting.

How long a metal roof lasts

Lifespan is where the higher price starts to make sense. Sources agree that metal outlasts asphalt by a wide margin, though the exact figures depend on the metal and the system.

Roof type Typical service life Source
Asphalt shingles 12 to 20 years Metal Roofing Alliance
Corrugated metal panels 20 to 40 years NRCIA
Metal shingles and tiles 40 to 60 years NRCIA
Standing seam 40 to 70 years NRCIA
Copper 80 to 100+ years NRCIA

Consumer Reports’ roofing guide says a metal roof can last anywhere from 50 to 100 years. The Metal Roofing Alliance cites 30 to 50+ years, with a true 30-to-50-year warranty.

The strongest field evidence comes from the Metal Construction Association’s service-life study of 14 standing seam roofs, some with up to 35 years in place across the US. It concluded that a similar roof built today with best practices can be expected to last in excess of 60 years, with the sealant at laps and joints being the deciding factor.

Plan for the whole system, not just the panel

The same study found that the steel panels held up exceptionally well, while fasteners and hardware were the components to watch, and it recommends periodic inspection and cleaning. NRCIA adds that underlayment, the protective layer under the panels, commonly needs replacement at 20 to 30 years, so a panel rated for 40 to 70 years should be inspected as a complete assembly. Good installation details and a periodic look at the roof are what carry a metal roof to the long end of its range.

Metal versus asphalt: cost over time

The Metal Roofing Alliance says a metal roof costs roughly two to three times what an asphalt shingle roof costs. It lasts 30 to 50+ years against 12 to 20 for asphalt. This Old House cites 40+ years for metal versus 20 to 30 for asphalt, notes that many metal roofs contain 30% to 60% recycled metal, and says they reflect solar heat, which can help with cooling costs.

Here is the logic with round, illustrative numbers. If an asphalt roof costs X and lasts 20 years, and a metal roof costs 2.5X and lasts 50, the cost per year is X/20 for asphalt and 2.5X/50 for metal, or X/20 for both. Beyond year 50, the metal roof is still working. That is before counting a second tear-off, which the longer-lived roof avoids.

Illustrative roof costs and lifespans compared

If you want to see the asphalt side of the equation, our page on a new asphalt shingle roof covers it. Many Northern Michigan homeowners who plan to stay for decades choose metal for exactly this reason.

Reading a metal roof quote

When you collect estimates, check that each one states:

  1. The metal, gauge and profile, for example steel standing seam with a named finish.
  2. Tear-off and disposal, and what happens if decking needs replacing.
  3. Underlayment, flashing, ridge, valleys and fasteners, itemized.
  4. Manufacturer and workmanship warranties, in writing.
  5. The contractor’s license number. Ours is Michigan Lic. #262500123.
  6. Who manages the project from start to cleanup.

With those six items in writing, you can compare quotes on the same footing, and the cost-per-year math above becomes meaningful.

Our view: price the roof by the decades

We hear the same question every time a homeowner starts looking at metal: is the price worth it? Our answer is to stop comparing a metal quote to an asphalt quote on day one and start comparing the cost of living under each roof for the next fifty years.

Metal is the roof we recommend for homeowners who plan to stay put. Northern Michigan asks a lot of a roof, and we pair metal with materials engineered for the local climate. Our installers use manufacturer-certified products, and every project gets a dedicated project manager so you always know who to call.

We also believe the price should be clear before the work starts. Our inspections are complimentary, and our pricing is transparent and fair, so the number you sign is the number you were shown. We carry an A+ rating with the BBB, and we are a local, community-trusted company.

The panel is only part of a metal roof. The details around it, the flashing, fasteners and underlayment, decide whether it reaches the long end of its life expectancy. That is where careful installation earns its keep.

Jack

Get a metal roof quote in Northern Michigan

If you are in Traverse City, Petoskey, Gaylord, Cadillac, Charlevoix, Alpena or nearby, Revive Exteriors will inspect your roof at no charge and give you a quote you can read line by line. We install metal roofing in standing seam, copper and other systems, and you can see the finished work on our metal roofing page and our copper standing seam installation.

Revive Exteriors

Start at revivemihome.com/roofing or call (866) 466-3351. Revive Exteriors, Michigan Lic. #262500123.

FAQ

How much does it cost to install a metal roof on a 2,000 sq ft home?

Using NerdWallet’s 2026 per-square-foot ranges, the arithmetic runs from about $8,000 for corrugated panels to $16,000–$28,000 for standing seam and $32,000–$60,000 for copper. Other cost guides run higher, up to about $58,000 for the same size home, depending on what they include. A written quote based on your roof’s shape and pitch is the number that counts.

How long do metal roofs last?

Standing seam systems are commonly cited at 40 to 70 years, and copper at 80 to 100+ years, according to NRCIA. Consumer Reports says a metal roof can last anywhere from 50 to 100 years. Proper installation and periodic inspection help a roof reach the long end of its range.

Is a metal roof cheaper than shingles in the long run?

The Metal Roofing Alliance puts the upfront cost at two to three times asphalt, with a life of 30 to 50+ years versus 12 to 20. Because it needs replacing far less often, many homeowners find the cost per year comparable, with added value from fewer tear-offs. Metal is typically a one-time purchase for as long as you own the home.

What cost factors matter most?

Labor, roof shape and pitch, the type of metal, and whether you choose hidden fasteners. Valleys, hips, dormers and steep slopes all add installation time, and labor is commonly 60% or more of the total.

Does the roof’s pitch change my quote?

Yes. The Metal Roofing Alliance says pitch and shape influence installation cost more than the style of metal chosen. Steeper roofs need special equipment and safety measures, which raise the price.

Revive Exteriors
Discuss Your Metal Roof
Reach out to Revive Exteriors to talk about metal roofing and the exterior remodeling options available for your home.

Sources

Revive Exteriors | (866) 466-3351 | revivemihome.com | Michigan Lic. #262500123